How do you fix a broken car radio?

How much does it cost to fix radio in car?

Repair rates run from $185 to $300, depending on the make and model. That may seem high, but new factory replacements can run almost twice that price.

What causes car radio to stop working?

Blown Fuse: One of the most common reasons for a car radio to stop working is a blown fuse. If the radio itself will not turn on, chances are good that there’s one or more blown fuses causing the problem. … A damaged antenna means that your radio isn’t able to receive signal from stations.

How much does a new car radio cost?

Total Cost



This is because components from different manufacturers vary in price depending on their quality. However, the least amount of money one can spend on a car’s stereo system is $400. On average, a high-quality car sound system will cost anywhere between $400 to $1100.

Does Walmart install car radios?

Standard Car Speaker Installation Service:



Orders are placed through Walmart.com and service is performed by InstallerNet. … Car audio system installation is performed by a certified technician.

How do I reset my car stereo system?

Devices with a reset button

  1. Remove the faceplate from your car stereo.
  2. Press the RESET button on the front panel using a pointed object, such as a ball-point pen.
IT IS INTERESTING:  Quick Answer: Can bad gas cause a flashing check engine light?

How do I reset the code on my car radio?

Turn on your radio and see if it displays CODE or LOC. If it does, turn off the radio. Press and hold down the audio power button together with the SEEK button for about 50-60 minutes. Then, it will turn on without entering the radio code.

How do you fix a blown fuse in a car radio?

How to Change a Fuse

  1. Locate your car’s fuse panel. …
  2. Take off the fuse panel’s cover. …
  3. Locate the blown fuse. …
  4. Remove the broken fuse. …
  5. Insert a replacement fuse of the correct amperage—make note of the fuse panel and your owner’s manual on this one. …
  6. Keep a few extra fuses of various amperages in your glove box.

How can I test my car radio?

Steps to Bench Test Your Radio

  1. Hold/Connect the yellow B+ wire to the positive terminal on the battery.
  2. Hold/Connect the red ACC wire to the positive terminal on the battery.
  3. Hold/Connect the black ground wire to the negative terminal on the battery.
  4. Press the left volume shaft to turn the radio on.
Help for your car