Why did my blower motor stop working?

In a situation where the motor doesn’t work on any speed, the most likely causes are: a blown power supply fuse, a bad motor ground connection, bad motor speed control module or a failed motor. On all systems, a failed blower motor is least likely. … Start by checking the blower fuse and HVAC controller fuse.

How do I know if my blower motor fuse is bad?

Symptoms of a bad heater blower motor resistor

  1. Fan does not work at all, so no air comes out of the vents.
  2. Fan only works on some speeds and not others.
  3. Fan only works on the highest speed.
  4. Fan runs all the time and can’t be controlled with the fan switch.
  5. You see smoke coming out of the vents.

What happens when blower motor relay goes bad?

If the blower motor relay develops any sort of problem that hinders its ability to properly limit and distribute power, it may cause the blower motor fuse to blow. Any sort of electrical spikes or excessive current from a bad relay will blow the fuse and cut power in order to protect the system.

Is there a fuse for blower motor?

Fuse Protection



To protect the blower motor power circuit, a 20-, 25- or 30-amp fuse is usually located in the fuse panel under the dash. The rating of the fuse will depend on the vehicle application and how much power the blower motor requires at full speed.

IT IS INTERESTING:  Question: How often should you replace struts on a car?

How much does it cost to replace a blower motor?

Cost to Replace Central or Forced Air Blower Motor



Replacing a blower motor costs $450 on average with a typical range of $250 to $800. With a warranty, you might pay as little as $150 for labor alone. For high-end models, like those with large motors or access issues, you might pay as much as $2,000.

How do you test a bad blower motor relay?

Connect a test light or multimeter to the ground (black lead). Turn the ignition key to the on position (engine off), and remove the relay. Using the probe, test all terminal sockets in the relay connector. Two of the four should have power.

How do I reset my blower motor?

How to Find and Reset your Furnace Motor Blower

  1. Step 1: Turn off the power to the furnace. …
  2. Step 2: Remove the blower compartment cover. …
  3. Step 3: Make sure the blower is completely cooled off. …
  4. Step 4: Locate the reset button. …
  5. Step 5: Press the button in (assuming that this is your issue and that the button has popped).

Where is the fuse for the blower?

Under the instrument panel, look under the glove box. On the right side of the fender wall you will find another fuse box. The blower motor fuse is easy to replace.

Help for your car