Where can I get my check engine light reset?

Can AutoZone clear a check engine light?

Does AutoZone Scan Check Engine Lights? AutoZone does. If your light is on, and you are wondering why, head down to your local AutoZone where one of our store associates can help diagnose the issue through our free Fix Finder service.

How much does it cost to get your check engine light reset?

The Best in Auto Repair



The average cost for check engine light diagnosis & testing is between $88 and $144. Labor costs are estimated between $88 and $144. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location. Related repairs may also be needed.

Can I reset my own check engine light?

The simplest most straightforward way to get rid of the check engine light is to drive it for a little bit, and the light will turn off by itself. Once you drove your car for a couple of days (e.g., usually three days), the check engine light should be gone.

IT IS INTERESTING:  Does Car shield cover transmission?

Where can I get my check engine light checked out?

You have a few options to get your check engine light diagnosed. You can take it to the dealer or an auto mechanic shop, to an auto parts store like AutoZone, or you can check it yourself with a scan tool. Dealer or auto mechanic shop.

Can low oil cause the check engine light to come on?

Low oil pressure



Low oil pressure is a common cause of a check engine light turning on, and it can seriously interfere with your car’s performance. Usually, if this is the case, your oil light will also appear. … In any case, low enough oil pressure will disable your vehicle, so get this repaired immediately.

Where can I get my check engine light read for free?

But you may not realize you might be able to get that problem checked for free at AutoZone or your other local auto parts stores. Many drivers don’t realize that AutoZone, the nation’s largest auto parts chain, will do the following services free of charge: Read the codes on your check engine light.

How do I permanently turn off my check engine light?

Push on the horn knob in the steering wheel and hold for 30 seconds. Connect back the wire to the car battery and continue with the + terminal followed by the – terminal. Tighten the clamps. Start your automobile and let the engine to heat up a little, the check engine light should automatically go OFF.

Why is my check engine light on but no codes?

Generally if the light is coming on and no codes are stored the processor that triggers the light is faulty or the circuit is shorted to power. disconnect that circuit from the ECU if the light goes off probably an issue with the ECU, if the light stays on look for a short to power on that circuit.

IT IS INTERESTING:  Is engine failure covered by insurance?

How long can you drive with a check engine light on?

When the Check Engine light comes on, you can still drive it for 50 to 100 miles, equivalent to 80 to 160 kilometers. It would be best if you took separate trips to help your car system assess its own status.

Does resetting your check engine light pass emissions?

If you clear the ‘Check Engine’ light, or reset the OBD-II monitors right before your emissions test, your vehicle typically will not pass because the catalyst and EVAP monitors need time to run. … If it’s not in a “ready” state, your vehicle will automatically fail.

Help for your car